Cisco ME 3400 Command Reference Manual page 584

show policy-map
This is an example of output from the show policy-map interface command for an interface with an
input policy applied:
Switch> show policy-map interface gigabitethernet0/1
GigabitEthernet0/1
Service-policy input: pin-police
Class-map: ip1 (match-all)
Class-map: class-default (match-any)
Table 2-18
grouped according to the relevant QoS feature.
Table 2-18
Field
Fields associated with classes or service policies
Service-policy
input/output
Class-map
packets
Match
Fields associated with policing
police
conform-action
conform
exceed-action
exceed
Fields associated with queuing
Queue Limit
Cisco ME 3400 Ethernet Access Switch Command Reference
2-556
0 packets
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip precedence 1
police cir 20000000 bc 625000
conform-action transmit
exceed-action drop
conform: 27927 (packets) exceed: 272073 (packets)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets
5 minute rate 0 bps
describes the fields in the show policy-map interface display. The fields in the table are
show policy-map interface Field Descriptions
Description
Name of the input or output service policy applied to the specified interface.
Class of traffic shown. Output appears for each configured class in the
policy. The choice for implementing class matches (match-all or match-any)
might also appear next to the traffic class.
Number of packets identified as belonging to the traffic class.
Match criteria specified for the class of traffic. This includes criteria such
as class of service (CoS) value, IP precedence value, Differentiated Services
Code Point (DSCP) value, access groups, and QoS groups.
Shown when the police command has been configured to enable traffic
policing. Displays the specified committed information rate (CIR) and
conform burst size (BC) used for policing packets.
Displays the action to be taken on packets marked as conforming to a
specified rate.
Displays the number of packets marked as conforming to the specified rate.
Displays the actions to be taken on packets marked as exceeding a specified
rate.
Displays the number of packets marked as exceeding the specified rate.
Queue size configured for the class in number of packets.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-10