Making Settings Required To Use The Software - Sony DVS-9000 User Manual

7
8
9

Making Settings Required to Use the Software

To use the software listed below, you are required to enter an install key which
validates the software. (If the software has been factory installed, the install key
is not required.)
For the method of obtaining an install key, contact your Sony representative.
To obtain a key, you may be required to submit the unique device ID of the
switcher you are using. You can check the unique device ID in the Install/Unit
Config menu of the switcher, using the following procedure.
BZS-9250
BZS-9420
BZS-9471
BZDM-9050
BZS-8050
a) This can be used only with a CCP-8000 series control panel equipped with the MKS-8010A.
To display the unique device ID
1
2
992
Installation and Device Setup (Install/Unit Config Menu)
Repeat steps 3 to 6, to confirm all software to be installed.
Press [Execute].
A confirmation message appears.
Press [Yes].
This carries out the installation, and when it completes normally, the
"Install" box shows "OK."
Simple P/P Software
Color Corrector Software
Texture Lighting Software (for BKDS-9470)
Texture Lighting Software (for MVE-9000)
Editing Control Software
In the System >Install/Unit Config menu, use either of the following
methods to select the device for which you want to register the license.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
Press [License].
The License menu appears as follows.
a)