Srx5800 Services Gateway Host Subsystem Description; Figure 4: Typical Spc - Juniper SRX5800 Hardware Manual

SRX5800 Services Gateway Hardware Guide
Related
Documentation

SRX5800 Services Gateway Host Subsystem Description

10

Figure 4: Typical SPC

For detailed information about SPCs supported by the services gateway, see the
SRX5600, and SRX5800 Services Gateway Card Reference
SRX5800 Services Gateway Card Cage and Slots on page 6
SRX5800 Services Gateway Field-Replaceable Units on page 279
Maintaining Interface Cards and SPCs on the SRX5800 Services Gateway on page 259
Troubleshooting SRX5800 Services Gateway SPCs on page 271
Replacing SRX5800 Services Gateway SPCs on page 308
The host subsystem is composed of a Routing Engine installed in a Switch Control Board
(SCB). The host subsystem provides the routing and system management functions of
the services gateway. You must install one host subsystem on the device. The host
subsystem components are as follows:
Switch Control Board
SRX5K-SCB–from Junos OS Release 9.2 to 12.3X48
SRX5K-SCBE–from Junos OS Release 12.1X47-D15 and later
SRX5K-SCB3–from Junos OS Release 15.1X49-D10 and later
Routing Engine
SRX5K-RE-13-20–from Junos OS Release 9.2 to 12.3X48
SRX5K-RE-1800X4–from Junos OS Release 12.1X47-D15 and later
SRX5400,
at
www.juniper.net/techpubs/
Copyright © 2015, Juniper Networks, Inc.
.