Figure 10: Front View Of A Fully Configured Services Gateway Chassis - Juniper SRX5800 Hardware Manual

SRX5800 Services Gateway Hardware Guide
20
WARNING: To meet safety and electromagnetic interference (EMI)
requirements and to ensure proper operation, you must properly ground the
services gateway chassis before connecting power. See
SRX5800 Services Gateway" on page 220
CAUTION: Before removing or installing components of a services gateway,
attach an ESD strap to an ESD point and place the other end of the strap
around your bare wrist. Failure to use an ESD strap can result in damage to
the services gateway.

Figure 10: Front View of a Fully Configured Services Gateway Chassis

Craft interface
Upper
fan tray
Card
slots 0-5
SCB0
SCB1
SCB2
or Card slot 6
Routing
engine
SPCs
IOCs
Card
slots 7-11
Air
filter tray
Lower
fan tray
Air intake
for instructions.
ESD point
Front-mounting
flange
Copyright © 2015, Juniper Networks, Inc.
"Grounding the
Center-mounting
bracket