Srx5800 Services Gateway Craft Interface Alarm Relay Contacts; Figure 16: Alarm Relay Contacts; Table 10: Alarm Relay Contact Functions - Juniper SRX5800 Hardware Manual

SRX5800 Services Gateway Hardware Guide
Related
Documentation

SRX5800 Services Gateway Craft Interface Alarm Relay Contacts

Table 10: Alarm Relay Contact Functions

Contact Label Contact Name
Normally Closed
NC
30
Online initiated, use "show chassis fpc" to verify
Verify that the MPC is online:
user@host> request chassis fpc slot 1 online node 0
node0:
--------------------------------------------------------------------------
FPC 1 already online
The command output indicates the MPC is online.
Confirm that the MPC in the chassis is online:
user@host> show chassis fpc
node0:
--------------------------------------------------------------------------
Slot State
0 Online
1 Online
2 Online
SRX5800 Services Gateway Craft Interface Overview on page 24
SRX5800 Services Gateway Craft Interface Fan LEDs on page 28
SRX5800 Services Gateway Craft Interface Alarm Relay Contacts on page 30
The craft interface has two alarm relay contacts for connecting the device to external
alarm devices (see Figure 16 on page
the major or minor alarm on the craft interface, the alarm relay contacts are also activated.
The alarm relay contacts are located on the upper right of the craft interface.

Figure 16: Alarm Relay Contacts

The alarm relay contacts consist of two sets of connectors, one set for each of the two
alarms (major and minor). For each alarm color there are three connectors.
Table 10 on page 30 describes the functions of the connectors.
Function
Connects the alarm relay to an external alarm-reporting device that
activates when the circuit between C and NC is closed.
Temp CPU Utilization (%)
(C) Total Interrupt
37 6 0
44 11 0
49 22 0
30). Whenever a system condition triggers either
Memory Utilization (%)
DRAM (MB) Heap Buffer
2048 19
1024 23
1024 14
Copyright © 2015, Juniper Networks, Inc.
14
29
25