Configuring Monitors - Avaya Scopia XT7000 Series Deployment Manual

2. Set the time after which the screen saver automatically starts on the display in the Screen
Saver field.
3. From the web interface only, select Save.
Related links
Configuring Basic Settings with the Quick Setup Wizard

Configuring Monitors

About this task
After you connect one or two monitors to the HDMI ports on the Avaya Scopia
configure the number of monitors, their resolutions, and the allowed video layouts. However, the XT
Executive only works with its own single monitor at a fixed resolution of 1080p.
Video layouts often require overlapping images when there are more video streams than available
monitors. For example, when your endpoint is disconnected, there is just local video stream which
fills the screen, or a local presentation from a PC. If you call another endpoint with no presentation,
there are two streams: the local and the remote video. If you add (send or receive) a presentation,
there are now three streams.
The available layouts depend on the number of monitors.
with presentation on page 112 shows the layouts for a single monitor. The PiP (Picture In Picture)
view shows a video image in the main screen, with an additional smaller image overlapping in the
corner. The PaP (Picture and Picture) view shows up to three images of the same size. The PoP
(Picture out Picture) view shows up to three images of different size, presented side by side, where
the image on the left is larger than the two smaller images on the right. For more information about
video layouts, see Avaya Scopia
January 2017
Figure 68: Configuring screen saver settings
®
XT Series User Guide.
®
Avaya Scopia XT Series Deployment Guide
Comments on this document? infodev@avaya.com
on page 98
®
Figure 69: Single monitor video layouts
Configuring Monitors
[1...96]
XT Series, you can
111