Updating The Xt Series - Avaya Scopia XT7000 Series Deployment Manual

Field Name
Address
Subnet mask
Table 55: Configuring SNMP settings (Edit section)
Field Name
Community
Enable all addresses
Address
Subnet mask
Enable Traps
3. From the web interface only, select Save.
Related links
Advanced Configuration of the XT Series

Updating the XT Series

This section describes how to upgrade the software running on the XT Codec Unit.
Important:
Any software version, even if it is restricted by a license, can run in a preview demo mode for 30
days. After that, you must enter a new license key or download the previous allowed version.
Version 3.0 does not require a license.
Upgrading to a major version requires a new license key. The first and second digits in the version
number indicate the major version number. For example, in version 3.1.0.005, the major version
number is "3.1".
The software update package is an auto-extracting file containing a software version, usually with a
filename indicating the exact version number, like XTn000_V8_3_2_515.exe. You must use a
package named XT5000 for the XT500/XT4n00/XTE240 series, and a package named XT7000 for
the XT7000 series. You can update the software version in several ways: remotely from Equinox
January 2017
Description
Enter the IP address of computers allowed to remotely access SNMP for
read operations.
Enter the Subnet mask to modify the Address field into a range of
addresses allowed to remotely access SNMP for read operations.
Description
Enter the name of the SNMP community that supports the edit (write)
operations of SNMP management. The community values are case-
sensitive. Typically there is a separate community for read (GET) called
public and a community for write (SET) called private.
Select No to restrict SNMP remote access for edit (write) operations to
specific computers in the range of the Address and Subnet Mask fields
below.
Enter the IP address of computers allowed to remotely access SNMP for
edit (write) operations.
Enter the Subnet mask to modify the Address field into a range of
addresses allowed to remotely access SNMP for edit (write) operations.
This field is a read-only field that indicates that SNMP traps are enabled.
on page 128
®
Avaya Scopia XT Series Deployment Guide
Comments on this document? infodev@avaya.com
Updating the XT Series
185