January - Avaya Scopia XT7000 Series Deployment Manual

2. Select the Enable auto-provisioning check box and select Apply.
The server service code for the Equinox Management server displays on the page.
This code can be used as a partial code for post-provisioning an endpoint.
3. To pre-provision the endpoint and generate an endpoint service code, select Endpoints,
and then select Add > Pre-provisioning an Endpoint.
The Pre-provisioning an Endpoint page opens, and the 5-digit server service code
generated in
endpoint service code. This full code enables the XT Series endpoint to connect to the
Equinox Management server when the XT Series administrator activates the pre-provisioned
endpoint, and the endpoint is automatically configured according to the pre-provisioned
profile.

January 2017

Provisioning Avaya Scopia
Figure 49: Auto-Provisioning Page
Figure 50: Server Service Code
Step 2 on page 85 displays at the top of the page, together with the 7-digit
Avaya Scopia
Comments on this document? infodev@avaya.com
®
®
XT Series Deployment Guide
XT Series Endpoints Automatically
85