Connecting Multiple Hdmi Devices Or Cameras Via The Avaya Scopia ® Xt Camera Switch - Avaya Scopia XT7000 Series Deployment Manual

Video
Hide thumbs Also See for Scopia XT7000 Series:
Table of Contents

Advertisement

Connecting Multiple HDMI Devices or Cameras via the Avaya
®
Scopia
XT Camera Switch
About this task
You can connect a second PTZ camera to your XT Series, for large room setups. All XT Series
models can connect the extra camera directly to the DVI port. However, the XT7000 Series and
XT5000 Series can also connect it via the Avaya Scopia
separately. Using the switch enables multiple HDMI connections and keeps the DVI port available
for a computer or DVD player to share content. For example, you may want to zoom one camera to
focus on the speaker, and use another camera for the audience.
On the XT7000 Series only, you can connect a second camera to an extra HDMI port on the XT
Codec Unit, without using the Avaya Scopia
Camera Switch when connecting more than two cameras to the XT7000 Series.
With the Avaya Scopia
devices, like a DVD or other media player.
Connected cameras can be controlled from an XT7000 Series or XT5000 Series endpoint.
Important:
The Avaya Scopia
Camera Switch.
Before you begin
Caution:
• Make sure all units are switched off when connecting or disconnecting devices.
• Always remove the camera stabilizing cartons before connecting the camera.
• Do not place a camera on top of the XT Codec Unit. It can cause the system to overheat.
Procedure
1. Install the Avaya Scopia
Unit. The supplied cable length is 40cm (0.13ft).
2. Connect the USB and HDMI cables as follows
Camera Switch to the XT Codec Unit
• Connect one end of the HDMI cable to the OUTPUT socket on the Avaya Scopia
Camera Switch and the other end to the vertical HDMI connector on the XT Codec Unit.
On the XT5000 Series, use the vertical HDMI port on the XT Codec Unit (located under
).
On the XT7000 Series, use the vertical HDMI 2 port on the XT Codec Unit (located under
).
January 2017
®
®
XT Camera Switch, you can connect up to four HD cameras or HDMI
®
XT4000 Series and XT Executive do not support the Avaya Scopia
®
XT Camera Switch on a horizontal surface close to the XT Codec
Avaya Scopia
Comments on this document? infodev@avaya.com
Connecting Cameras or DVD players
®
XT Camera Switch which is purchased
XT Camera Switch. Use the Avaya Scopia
(Figure 27: Connecting the Avaya Scopia
on page 56):
®
XT Series Deployment Guide
®
XT
®
XT
®
XT
®
XT
55

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents