Config: Ip  Ip Setup: Stats - Comtech EF Data CDM-625A Installation And Operation Manual

Advanced satellite modem (18 kbps – 25 mbps)

Hide thumbs Also See for CDM-625A:

Table of Contents

CDM-625A Advanced Satellite Modem

Front Panel Operation

Define Port Priority by using the

arrow keys to designate a priority from 1 to 4 (with Priority 4 being the highest).

CONFIG: IP  IP Setup: QoS L3 QoS

When the optional IP Packet Processor card is either not installed or installed but disabled, and

L3 QoS is selected, this menu is disabled and appears as follows:

(Fixed at Off)

Otherwise, when the optional IP Packet Processor card is installed and enabled, the L3 QoS

menu appears as follows:

(Off,Max/Prio,MinMax,DiffServ)

arrow keys to set the L3 QoS operational priority. Press ENTER.

Valid settings are:

6.2.1.13.3.9 CONFIG: IP  IP Setup: Stats

IPstats: Port x

This screen displays IP traffic statistics for both the In (Ingress) and Out (Egress) directions. Use

arrow keys to navigate to the proper line, in this order:

First, on the top line – Use the

Ports 1 through 4, HDLC FPGA, or Management. ("In" and "Out" are column labels for the

bottom line parameters and are not selectable.)

Next, on the bottom line – Use the

arrow keys to select the port (P1, P2, P3, or P4), and then

QoS disabled.

(Maximum priority only) Provides multi-level traffic prioritization with the ability to limit

maximum traffic per priority class.

(Minimum/Maximum priority) Provides a Committed Information Rate (CIR) to each

user-defined class of traffic with the ability to allow a higher burstable rate depending

on availability.

(DiffServ priority only) Industry-standard method of providing QoS, enabling

seamless co-existence in networks that implement DiffServ.

arrow keys to select the bottom-line IP Stats Type as WAN,

arrow keys to view the desired statistical parameter.

Chapters

Table of Contents