Configuration | Routing | Dhcp; Dhcp Relay - Comtech EF Data CDM-625A Installation And Operation Manual

Advanced satellite modem (18 kbps – 25 mbps)

Hide thumbs Also See for CDM-625A:

Table of Contents

CDM-625A Advanced Satellite Modem

Ethernet-based Remote Product Management

Configuration | Routing | DHCP

Use this page to set up the DHCP (Dynamic Host Configuration Protocol) Relay feature.

DHCP allows a device to be configured automatically – eliminating the need for intervention by a

network administrator – and provides a server located at the hub for keeping track of devices

that are connected to the network. This prevents two devices from accidentally being

configured with the same IP Address.

The CDM-625A DHCP Relay feature allows you to deploy a single DHCP server at the hub that

manages all of the devices throughout your remote networks. When a device on the CDM-

625A's network issues a DHCP request, it is relayed to the DHCP server as specified by the

"DHCP Server IP Address". The DHCP response is then sent directly to the requesting device.

Relay Feature – Use the drop-down list to Disable or Enable the DHCP Relay Feature.

DHCP Server IP Address – Specify the IP Address to be used for the DHCP server at the hub

in the form XXX.XXX.XXX.XXX.

Click [Submit] to save.

Figure 7-18. Configuration | Routing | DHCP page

Table of Contents