Select: Test  Bert; Select: Test  Bert  Config; Select: Test  Bert  Monitor; Select: Test  Cnc-Apc-Monitor - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation
6.2.2.2 SELECT: TEST  BERT
BERT: Config
Use the ◄ ► arrow keys to select Config or Monitor. Press ENTER.
6.2.2.2.1 SELECT: TEST  BERT  Config
BERT
Cnfg
Use the ◄ ► arrow keys to select a BERT configuration parameter, and then use the
keys to select a parameter setting.
Available settings are:
Option
Tx/Rx Options
ErrIns Options
Pattern Options
6.2.2.2.2 SELECT: TEST  BERT  Monitor
BERT Monitor:
Press ENTER to restart the BERT Monitor.
6.2.2.3 SELECT: TEST  CnC-APC-Monitor
CNC-APC: BER=N/A
The test results provided on this screen are:
Test
BER
FER
To restart either Test, use the
Monitor
Tx:Off Pattern=2047
Rx:Off Pattern=2047
Setting
Off or On
Off or 10E-3
Space, Mark, 1:1, 1:2, 63, 511, 2047, 2047R, MIL188, 2
Errs=0000000
BER=0.0E-07
Reset
Description
Bit Error Rate
Frame Error Rate
◄ ►
arrow keys to select (BER) Reset or (FER) Reset. Press ENTER.
6–77
()
ErrIns=Off
()
-1, 2
15 20
Sync: OK
Restart
FER=N/A Reset
()
MN-CDM625A
Revision 4
arrow
▲▼
-1, 2 -1
23