Config: Ip  Portmonitor - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation
Press ENTER.
CONFIG: IP  ANT  PTP: Transport=Unicast
PTP Unicast Master = 192.012.002.021
Sync Rate = 1 Message every 2 seconds
Once you select Unicast, use the
On the top line – To edit the PTP Unicast Master IP Address, use the
digit, and then use the
On the bottom line – Use the
per second for messages sent from the Master to the Slave. Available selections are:
• 1 message per second
• 4 messages per second
• 32 messages per second
You may use Sync Rate only when the Grandmaster is LAN port and the Transport
Mode is Unicast.
6.2.1.13.5 CONFIG: IP  PortMonitor
Port Monitor: Enabled
Destination=Port 3
Port monitoring allows a port's ingress and/or egress traffic to be mirrored on another port. This
is useful for link monitoring or packet capturing without interrupting live traffic.
Use the ◄ ► arrow keys to move the cursor to the function; then, use the
the function parameter. Press ENTER.
Valid selections are:
Function
Port Monitor
Source
Destination
Direction
◄ ►
arrow keys to navigate between the top and bottom line.
arrow keys to change that digit. Press ENTER.
▲▼
arrow keys to select the synchronization interval of packets
▲▼
• 1 message every 2 seconds
• 8 messages per second
• 64 messages per second
Setting
Enabled or Disabled.
WAN, Port 1, Port 2, Port 3, or Port 4.
Port 1, Port 2, Port 3, or Port 4. (You may not select the active "Source" Port.)
Ingress, Egress, or Both.
Source=Port 2
Direction=Both
6–73
MN-CDM625A
Revision 4
◄ ► arrow keys to select a
• 2 messages per second
• 16 messages per second
()
arrow keys to set
▲▼