Radius Operation Using The Cdm-625A Front Panel - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Appendix T
T.4.1

RADIUS Operation Using the CDM-625A Front Panel

Figure T-2. CDM-625A Front Panel Keypad and Vacuum Fluorescent Display
Chapter 6. FRONT PANEL OPERATION
•
Access to and operation of the CDM-625A Front Panel is not controlled by
RADIUS.
• Control of RADIUS operations from the front panel is limited only to enabling
and disabling the feature.
• Configuration of RADIUS features is possible only using Telnet remote
commands or the HTTP (Web Server) Interface Admin | Access page.
From the front panel main (SELECT:) menu, use the
menu branch, and then press ENTER. From the CONFIG: menu branch, use the
to select the IP submenu, and then press ENTER. From the IP Config: submenu, use the arrow
keys to select Setup, and then press ENTER. From the IP Setup submenu, use the
keys to select Rad.
SELECT: Configuration
Info
CONFIG:
CnC
IP Config: Addresses
IP Setup: Mode
MAC-Lrng Rad VLAN QoS Stats FrmSize ()
RADIUS: Disabled (Enabled, Disabled)
Use the arrow keys to select RADIUS operation as Enabled, and then press ENTER.
▲▼
Store/Ld Utility
All Mode
EDMAC Misc Mask
ANT AccessList
WAN
◄ ► arrow keys to select the Configuration
Test Monitor
ODU FAST
Tx Rx Clocks D&I/ACM
Remote IP
SNMP Setup
PktP-Enable
PerPortCnfg DDMgmtPt
T–6
MN-CDM625A
Revision 4
◄ ► arrow keys
◄ ► arrow
()
()
()
()