CDM-625A Advanced Satellite Modem
Front Panel Operation
6.2.1.13 CONFIG: IP
IP Config:
PortMonitor AccessList
arrow keys to select a parameter. PktP-Enable displays only when you install the
Use the
◄ ►
the optional IP Packet Processor card.
Press ENTER to continue.
6.2.1.13.1
CONFIG: IP Addresses
IP Addresses:
Use the
◄ ►
arrow keys to select MAC, Gateway, or Addr/Range. Press ENTER.
CONFIG: IP Addresses MAC
Ethernet MAC Address:
00-06-B0-00-01-06
This screen displays the read-only unit MAC address.
Press ENTER or CLEAR to return to the previous menu.
CONFIG: IP Addresses Gateway
Ethernet IP Gateway:
192.168.001.002
Edit the IP Gateway Address for the Ethernet M&C port for this unit by using the
to select a digit. Then, use the
CONFIG: IP Addresses Address/Range
Ethernet IP Address/Range:
192.168.001.002/24
Configure the IP Address for the Ethernet M&C port for this unit by using the
select a digit. Then, use the
Addresses
Addr/Range
arrow keys to change that digit. Press ENTER.
▲▼
arrow keys to change that digit. Press ENTER.
▲▼
SNMP
Setup
PktP-Enable()
MAC
Gateway
(read-only)
6–55
MN-CDM625A
Revision 4
ANT
()
()
◄ ►
arrow keys
()
◄ ►
arrow keys to