Configuration | Lan | Arp - Comtech EF Data CDM-625A Installation And Operation Manual

Advanced satellite modem (18 kbps – 25 mbps)

Hide thumbs Also See for CDM-625A:

Table of Contents

CDM-625A Advanced Satellite Modem

Ethernet-based Remote Product Management

VLAN Table – This read-only table provides the user with the status for VLAN entry on a per-

ID (0001-4095) and per-Port (1-4) basis, where U=Untagged, T=Tagged, and F=Filtered.

Configuration | LAN | ARP

This nested page is accessible only to Admin users and when you install and enable

the optional IP Packet Processor card. See Sect. 7.5.3.1 for complete details about

using conditional access pages.

ARP (Address Resolution Protocol) is a technique by which the HTTP Interface in Router Mode

on a given network answers the ARP queries for a network address that is not on this network,

but is reachable via the IP Packet Processor Interface.

Use this page to configure the modem's ARP parameters.

ARP Table (Edit)

This section displays all current Static and Dynamic ARP entries, and allows to user to directly

edit the current Static ARP entries, when more than one ARP entry exists. Note the following:

Click [Submit Changes] to save.

Figure 7-14. Configuration | LAN | ARP page

This is the internal table index that is automatically assigned and cannot be edited.

IP Address, in the format XXX.XXX.XXX.XXX.

MAC Address, in the format YY:YY:YY:YY:YY:YY.

Type is identifiable as Static or Dynamic (cannot be edited).

Table of Contents