Fast: Options  Set Register1 Or Set Register 2 - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation
6.2.8.1.2 FAST: Options  Set Register1 or Set Register 2
Chapter 5. FAST ACTIVATION PROCEDURE
FAST: Set register#:
88888888888888888888
Where '#' is '1' or '2': Use FAST: Options  Set Register1 and Set Register 2 to enable new
options in the modem on a per-register basis. It is important to use the appropriate FAST access
code for the appropriate register.
Contact Comtech EF Data Product Support to order the desired options (see Sect. 6.2.8.1.1) – be
prepared to provide the Modem Serial Number. The representative will verify the order and
provide an invoice and instructions, including a register-specific 20-digit FAST Access Code.
ENTER the FAST Access Code that you have obtained from Comtech EF Data carefully using the
front panel keypad or, alternately, the CDM-625A Web Server (HTTP) Interface:
From the CDM-625A front panel – First, use the
•
use the
▲▼
ENTER only when you are ready to execute the upgrade.
The modem responds with "Configured Successfully" upon completion of the
FAST upgrade; the modem then resets to its newly incorporated default configuration.
However, if you ENTER an invalid code, the modem rejects the entry and the unit prompts
you to re-ENTER the code as follows:
Failed to configure. Re-ENTER code.
88888888888888888888
Repeat the FAST access code entry procedure. Should the code entry error persist, contact
Comtech EF Data Product Support for further assistance.
• From the CDM-625A Web Server Interface – See Sect. 6.5.4.2.5 Admin | FAST.
arrow keys to change that digit. Compose the code carefully, and then press
ENTER code below
then [ENTER] ()
◄ ► arrow keys to select a digit, and then
then [ENTER] ()
6–102
MN-CDM625A
Revision 4