Config: Mask  Lnb; Config: Mask  Clkext (G.703 Clock Extension Mask) - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation
control). For a modem in a 1:1 redundancy setup, you must customize the fault indications for
the physical setup.
6.2.1.11.10 CONFIG: Mask  LNB
Chapter 10. CDM-625A ODU (TRANSCEIVER, BUC, LNB) OPERATION
LNB alarm = Active
Attach to Rx alarm = No
When L-Band is in use, you may include a Low-Noise Block Down Converter (LNB) in the
operating system. You can use the modem only to monitor and control the power supply values.
For a modem in a 1:1 redundancy setup, you must customize the fault indications for the
physical setup.
6.2.1.11.11 CONFIG: Mask  ClkExt (G.703 Clock Extension Mask)
G.703 Clock Extension = Active
(Active, Masked)
Use the arrow keys to select Active or Masked. Press ENTER.
▲▼
When you select Active, the modem generates a ClkExt (Clock Extension) alarm if the G.703
Clock Extension mode is set to TxLock and the input is lost or removed from the G.703 interface.
(Active,Mask)
(Yes,No)()
6–53
MN-CDM625A
Revision 4
()