Telnet Interface; Using The Telnet Interface For Standard Remote Control Protocol - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Ethernet-based Remote Product Management
7.4

Telnet Interface

•
Chapter 8. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
• Chapter 9. TELNET COMMAND-LINE INTERFACE (CLI) OPERATION
Comtech EF Data provides a Telnet interface for the purpose of equipment monitor and control
(M&C) using either the standard remote control protocol or, when the optional IP Packet
Processor is installed and Enabled, the Telnet Command Line Interface (CLI).
7.4.1

Using the Telnet Interface for Standard Remote Control Protocol

Do these steps to use Windows Command-line to access the CDM-625A Telnet Interface:
1. Click [Start] on the Windows taskbar, and then click the Run... icon (or, depending on
Windows OS versions prior to Windows 95, click the MS-DOS Prompt icon from the Main
Menu).
2. Next, open a Command-line window...
•
For Windows 95 or Windows 98, type "command" (or, for any Windows OS versions
later than Windows 98, type "cmd" or "command"):
• Alternately, from [Start], select All Programs > Accessories > Command Prompt.
3. From the Command-line prompt (c:\>), type "telnet xxx.xxx.xxx.xxx" (where
'xxx.xxx.xxx.xxx' is the modem's Ethernet Traffic/Management IP Address).
4. Access requires login at the Administrator and Read/Write User Access Levels. Once you log
in as the Administrator, you may issue remote commands and queries over the CDM-625A
Telnet Interface, as this example shows:
7–5
MN-CDM625A
Revision 4