Http (Web Server) Interface; User Login - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Ethernet-based Remote Product Management
7.5

HTTP (Web Server) Interface

A user-supplied Web browser allows the full monitor and control (M&C) of the CDM-625A from
its HTTP Interface. The CDM-625A's embedded web application is designed for, and works best
with, Microsoft's Internet Explorer Version 9.0 or higher. Comtech EF Data does not recommend
setting your browser to IE7 Compatibility Mode.
7.5.1

User Login

Type the CDM-625A's Traffic/Management IP Address (shown here as http://xxx.xxx.xxx.xxx)
into the Address area of the user PC Web browser:
The Login window will appear, similar to the
example shown here, opens. Enter the
assigned User name and Password. The HTTP
Interface default user names and passwords
are as follows:
•
Admin
•
Read/Write
• Read Only
HTTP Login User Access Levels are further defined as follows:
Admin User
Full Access to all
web pages.
Type the User Name and Password, and then click [OK].
Once the valid User Name and Password is
accepted, you will see the CDM-625A HTTP
Interface "splash" page, as per the following
example (note that the Base Modem and
optional IP Packet Processor Firmware
Versions listed here are subject to change):
To properly access the CDM-625A HTTP
Interface, you must first set remote control
access for the unit to Ethernet mode. If you
attempt to log in to the HTTP Interface and
comtech/comtech
opcenter/1234
monitor/1234
HTTP Login User Access Level
Read/Write User
No Access to Admin or IP Packet Processor-
related web pages.
Full Access for all other web pages
Read Only User
No Access to Admin or IP Packet Processor-
related web pages.
View Only Access for all other web pages.
7–8
MN-CDM625A
Revision 4