Wireless Lan Specifications (Option); Regulatory Wireless Lan Statements - Oki MC853 User Manual

Wireless LAN Specifications (Option)

Item
Wireless LAN standard
Transfer rate
Antenna system
Security

Regulatory wireless LAN statements

- FCC Statement
- IC Statement
- Europe-CE Declaration of conformity.
FCC statement
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
IC statement
This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of this device.
Le présent appareil est conforme aux la partie 15 des règles de la FCC et CNR d'Ubdustrie
Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) I'appareil ne doit pas produire de brouillage, et (2)
I'utilisateur de I'appareil doit accepter tout brouillage radioélectrique subi, même si le
IEEE802.11a/b/g/n conformity (2.4 GHz / 5 GHz)
IEEE802.11n: Max 150 Mbps
IEEE802.11g: Max 54 Mbps
IEEE802.11b: Max 11 Mbps
IEEE802.11a: Max 54 Mbps
Built-in Antenna1T1R
Disable, WPA2-PSK, WPA2-EAP
1053