Table of Contents
Advertisement
Setting This Machine
To enable IPSec, you must set this machine by using the Web page in advance.
Note
If IPsec is set to this machine and the host, IPSec communication is established. If IPSec is
not set to the host, IPSec communication is not established.
Do not forget to take notes of the values specified in this procedure. These values are
necessary when setting IPSec on a computer.
1.
Open the Web page of this machine.
How to log in to the Web page
Checking or Changing the Settings of This Machine from a Computer
2.
Log in as the administrator.
3.
Select [Admin Setup].
4.
Select [Network] > [Security] > [IPSec].
5.
Specify detailed settings by following the on-screen instructions.
Memo
You must enable either [AH] or [ESP] in the [Phase2 Proposal] setting.
6.
Click [Submit].
The new settings take effect when the network function of this machine restarts.
Note
If you were unable to set up IPSec due to the inconsistency of the parameters that were
specified, you cannot access the Web page. In such a case, disable the IPSec from the operator
panel of this machine or initialize the network settings.
Topics
Proceed to setting a computer.
Setting a Computer
1141
Advertisement
Table of Contents
