Table 13: Diagnostic Reports; Table 14: Relay Reports - Bosch D9412GV3 Program Entry Manual

D9412GV3/D7412GV3 | Program Entry Guide | 2.0

Table 13: Diagnostic Reports

Report
1
R# SDI Dev Fail
R# SDI Dev Restl
R# Watchdog
Rset
R#
ParaChksmFail
R# Reboot
1
R# Ph Line Fail
R# Ph Line Rstl
1, 2
R# AC Fail
2
R# AC Restorl
1, 2
R# Batt Missing
1, 2
R# Battery Low
2
R# Battery Rstl
1,
R# Rt Comm Fail
3
R# Rt Comm Rstl
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
Selections Report
Description
Yes, No SDI device
failure
Yes, No Restoral of SDI
device failure
Yes, No Watchdog
Reset Event
Yes, No Parameter
checksum
failure
Yes, No Reboot Event
Yes, No Failure of phone
line
Yes, No Restoral of
phone line after
failure
Yes, No
Failure of AC
power to control
panel
Yes, No Restoral of AC
power to control
panel after
failure
Yes, No Battery Missing
Detection Event
Yes, No
Low battery
power
Yes, No Restoral of
battery power to
control panel
after Missing or
Low Event
Yes, No Failure to send
report to
specific route
Yes, No Restoral of
communication
to specific route
after a failure
Get other manuals https://www.bkmanuals.com
Panel and Area Wide Parameters
Table 13: Diagnostic Reports (Continued)
Report Selections
R# Rt Comm Rstl Yes, No
R# Checksum Fail Yes, No
4
Yes, No
R# Network Fail
4
Yes, No
R# Network Rest
4
Yes, No
R# Network Cond
1
This event is included in the Expanded Test Report
when an off-normal condition exists.
2
To meet UL 864 requirements for Central Station and
Remote Station applications, enable AC Fail, Battery
Missing, Low Battery, Battery Restoral, and AC
Restoral reports.
3
This event covers Comm Fail Route Group and Comm
Fail Phone. If enabled, both events are sent; if
disabled, neither event is sent.
4
This event is reserved for future use.
Enable Rt Comm Fail and Rt Comm
Restore in only one route group.
Relay Reports
Selecting Yes enables sending a report when the
event occurs.

Table 14: Relay Reports

Report Selections
R# Sensor Yes, No
Reset
R# Relay Set Yes, No
R# Relay Yes, No
Reset
EN | 24
Report
Description
Restoral of
communication
to specific
route after a
failure
Checksum Fail
Event
Failure of
network
Restoral of
network
Condition of
network
Report
Description
Sensor Reset
Event
Relay Set Event
Relay Reset Event