Channelized Line Card Standby Led States - Cisco ASR 5000 Installation Manual

Card-Level LEDs on the Channelized (STM-1/OC-3) Line Card
Table 74: Channelized Line Card Active LED States
Color
Green
None

Channelized Line Card Standby LED States

The Standby LED on the channelized line card indicates that software is loaded on the card and it is serving
as a redundant component.
The installed line cards remain in ready mode until their corresponding packet processing card is activated
via configuration. While in ready mode, the Active LED is off. After the packet processing card is activated,
the line card installed in the upper-rear chassis slot behind the packet processing card is activated. The line
card installed in the lower-rear chassis slot behind the packet processing card enters standby mode.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 75: Channelized Line Card Standby LED States
Color
Green
ASR 5000 Installation Guide
162
Description Troubleshooting
Card is active None needed for line cards installed in slots 17 through 23 and
26 through 32 after configuration.
If green for line cards in slots 33 through 39 and 42 through 48,
verify that the corresponding line card installed in the upper-rear
chassis slot is installed properly according to the instructions in
this document.
For example, if this LED is green for a line card in slot 33, verify
that the line card in slot 17 is installed properly.
Card in Ready Mode This is normal prior to configuration. Neither the Active or the
Standby LED on the card will be on.
OR
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power
power and POST test results are positive. If it is off, refer to
Channelized Line Card Run/Fail LED States, on page 161
OR
troubleshooting information.
Card in Standby Mode
Check the state of the Standby LED. If it is green, the card is in
standby mode. Refer to the System Administration Guide for
information on making the card active.
Description Troubleshooting
Card is in redundant None needed for line cards installed in slots 33 through 39 and
mode 42 through 48 after configuration.
If green for line cards installed in slots 17 through 23 and 26
through 32, refer to the System Administration Guide for
troubleshooting information.
Applying Power and Verifying the Installation
for