Chapter - Cisco ASR 5000 Installation Manual

Adding Application and Line Cards to an Existing Installation
To reduce the risk of electric shock and to ensure proper ventilation, blanking panels must be used to cover any chassis
slot that is not occupied by an application card.
Leere Steckplaetze muessen mit der dafuer vorgesehenen Abdeckplatte geschlossen werden, um die Luftzirkulation
innerhalb des Geraets zu gewaehrleisten und um einen elektrischen Schlag zu vermeiden.
a) Position the blanking panel over the unused chassis slot(s).
b) Use a Phillips #2 screwdriver to tighten the screws at the top and bottom of the blanking panel to secure the panel to
the chassis.
Step 11
Refer to one of the following chapters in this guide for information on cabling the line cards you just installed.
Line Card
Switch Processor Input/Output (SPIO)
Fast Ethernet Line Card (FLC2)
Gigabit Ethernet Line Card (GLC2)
Quad Gigabit Ethernet Line Card (QGLC)
10 Gigabit Ethernet Line Card (XGLC)
Optical (ATM) (OLC2)
Channelized Line Card Interfaces (CLC2)
Adding a 10 Gigabit Ethernet Line Card
The 10 Gigabit Ethernet Line Card (XGLC) is a full-height line card that occupies two half-height slots in
the rear of the ASR 5000 chassis. It accepts a single Small Form-factor Pluggable+ (SFP+) transceiver module
for network connectivity.
There are two versions of the XGLC:
• XGLC SR: Accepts a 10GBase-SR module for a fiber optical cable with a center wavelength of 850nm
• XGLC LR: Accepts a 10GBase-LR module for a fiber optical cable with a center wavelength of 1310nm
Install XGLCs behind packet processing cards. You can install a maximum of twelve XGLCs in the chassis.
terminated by an LC connector. It can drive an optical signal up to 300 meters using 50/125um fiber
(MMF), and up to 33 meters using 62.5/125um fiber (MMF).
terminated by an LC connector. It can drive an optical signal up to 10 kilometers using 50/125um fiber
(SMF).

Chapter

Cabling the Switch Processor Input/Output Line Card
Cabling the Ethernet 10/100 Line Card
Cabling the Gigabit Ethernet Line Cards
Cabling the Optical (ATM) Line Card
Cabling the Channelized Line Card
Adding a 10 Gigabit Ethernet Line Card
ASR 5000 Installation Guide
181