What To Do With The Failed Fan Tray - Cisco ASR 5000 Installation Manual

What to do with the Failed Fan Tray

Step 4
Replace the fan tray bay cover/EMI shield. The perpendicular tabs on the cover should face away from the chassis and
be positioned at the bottom. Use a Phillips #1 screwdriver to hand tighten the four captive screws in an alternating pattern
– upper left, lower right, lower left, upper right (5 inch-lbf, 0.5 N-m). Do NOT use an electric or pneumatic torque
driver to tighten these screws.
Step 5 Replace the lower plastic bezel by aligning it over the bezel mounts that protrude from the fan tray bay cover and snapping
the it in place.
What to do with the Failed Fan Tray
If the failed fan tray is still under warranty, return it to the vendor for repair.
If the failed fan tray is out of warranty, contact Cisco to determine if it can be sent in for repair at an additional
cost.
Important
Refer to the support area of http://www.cisco.com for up-to-date product documentation pertaining to
installation, configuration, and maintenance. A valid username and password is required to use this site. Please
contact your local sales or service representative for additional information.
Important
ASR 5000 Installation Guide
212
Disposal of this product should be performed in accordance with all national laws and regulations.
For additional information on the RMA process, see the RMA Shipping Procedures appendix.
Replacing Upper or Lower Fan Tray