Asr 5000 Installation Guide - Cisco ASR 5000 Installation Manual

Reducing the Weight of the Chassis Prior to Installation
a) Unsnap the plastic bezel from the lower-front of the chassis by placing your fingers in the notches on the sides of the
bezel and pulling it toward you. Place it to the side for re-installation later.
b) Use a Phillips #1 screwdriver to loosen the four captive screws that hold the fan tray cover/EMI shield in place. Pull
the cover away from the chassis. Do NOT use an electric or pneumatic torque driver to loosen these screws.
c) Pull the fan tray toward you using the handle. The fan tray should easily slide out of the chassis. Place it to the side
for re-installation later.
To avoid personal injury and/or damage to the fan tray, be sure to support the fan tray's weight from its front and
back as you slide it completely out of the chassis.
Vorsicht beim Herausziehen der Luefter-Schublade: um eine Beschaedigung des Moduls und eventuelle Verletzungen
zu vermeiden, sollte diese hinten und vorne unterstuetzt werden.
Step 3 Remove the PFUs located in the lower-rear of the chassis.

ASR 5000 Installation Guide

56
Chassis Installation