Cisco ASR 5000 Installation Manual page 243

Replacing Line Cards
Step 3 Push the ejector levers inward firmly and straight until the card is firmly seated in the chassis midplane and the ejector
levers can be pushed in no further. Press firmly on the card's faceplate to ensure that it is fully seated. The card's front
panel should be flush against the chassis' upper and lower card mounts for the slot.
Step 4 Slide the interlock switch on the front panel of the line card upward to lock the ejector tab in place. The flange on the
left-side of the interlock switch prevents movement of the ejector tab when raised completely.
You must slide the interlock switch upward before securing the card's top screw to the mounting
Important
rail.
Step 5 Use a Phillips #2 screwdriver to tighten the screws at the top and bottom of the line card's front panel to secure the card
to the chassis.
Step 6
Refer to the destination label on each cable and re-attach the cables to the line card. Refer to the following table to locate
the chapter of this guide that provides information and instructions on cabling the line card.
Installing the Line Card
ASR 5000 Installation Guide
227