Asr 5000 Installation Guide - Cisco ASR 5000 Installation Manual

Periodic Status Checks
Table 81: Periodic Status Checks
To do this:
Monthly
Check for unused or unneeded file on the CompactFlash.
Delete unused or unneeded files to conserve space using the
delete command. You should also perform the next action
in list. See Note below.
Synchronize the contents of the CompactFlash on both SMCs
to ensure consistency between the two (Exec mode
command).
Generate a crash list (and other show command information)
and save the output as a tar file.
NOTE: If there is an issue with space, you can remove alarm and crash information from the system;
however, this practice is not recommended. Support and engineering personnel use these records for
troubleshooting if a problem should develop. You should request assigned support personnel to remove
these files after storing the information for possible future use.
Every 6 Months
View a listing of all cards installed in the chassis with
hardware revision, part, serial, assembly, and fabrication
numbers.
View all cards installed in the chassis with hardware revision,
and the firmware version of the on-board Field Programmable
Gate Array (FPGAs).
You should replace the particulate air filter installed directly above the lower fan tray in the chassis. Refer
to the Replacing the Chassis Air Filter section of this guide for detailed instructions.

ASR 5000 Installation Guide

172
System Monitoring
Enter this command:
dir /flash
delete /flash/<filename>
filesystem synchronize all
show support details <to location and
filename>
Flash: [file: ]{ /flash | /pcmcia1 | /hd }[
/directory ]/file_name
TFTP: tftp://{ host[ :port# ] }[ /directory
]/file_name
SFTP: [ ftp: | sftp: ]//[ username[ :password
]@ ] { host }[ :port# ][ /directory ]/file_name
NOTE: In release 20.0 and higher Trusted
StarOS builds, FTP is not supported.
show hardware card
show hardware inventory
show hardware system
show hardware version board