Asr 5000 Installation Guide - Cisco ASR 5000 Installation Manual

ASR 5000 Hardware Platform Overview
of the base station subsystem (BSS) in a mobile network. These interfaces are commonly used with the SGSN
product to support frame relay.
In North America, the card supplies ANSI SONET STS-3 (optical OC-3) signaling. In Europe, the card
supplies SDH STM-1 (optical OC-3). The transmission rate for the card is 155.52 Mbps with 336 SONET
channels for T1 and 252 SDH channels for E1.
Each CLC2 provides four optical fiber physical interfaces (ports). The ports are populated by a Small
Form-factor Pluggable (SFP) modules which include an LC-type connector. The ports of the CLC2 supports
two types of SFP modules and cabling, as shown in the following table.
Table 20: SFP Modules supported by the CLC2
Module Type
Single-mode
Optical Fiber
Multi-mode
Optical Fiber
The CLC2 supports the Star Channel (1 Gbps) for faster FPGA upgrades and is Restriction of Hazardous
Substances (RoHS) 6/6 compliant.
Install the CLC2 directly behind its respective (Active) packet processing card. You may optionally install
CLC2s behind a redundant (Standby) packet processing card. As with other line cards, install the Channelized
Line Cards in slots 17 through 23, 26 through 39, and 42 through 48.
Card Interface
Identification Type
Channelized Single-mode
(STM-1/OC-3) Fiber, LC
SM IR-1 duplex
female
connector
Channelized Multi-mode
(STM-1/OC-3) Fiber, LC
Multi-Mode duplex
female
connector
Cable Specifications
Fiber Types: Single-mode optical fiber
Wavelength: 1310 nm
Core Size: 9 micrometers
Cladding Diameter: 125 micrometers
Range: Intermediate/21 kilometers
Attenuation: 0.25 dB/KM
Min/Max Tx Power: -15 dBm/-8 dBm
Rx Sensitivity: -28 dBm
Fiber Types: Multi-mode optical fiber
Wavelength: 1310 nm
Core Size: 62.5 micrometers
Cladding Diameter: 125 micrometers
Range: Short/2 kilometers
Min/Max Tx Power: -19 dBm/-14 dBm
Rx Sensitivity: -30 dBm

ASR 5000 Installation Guide

Channelized Line Card (CLC2)
35