Asr 5000 Installation Guide - Cisco ASR 5000 Installation Manual

ASR 5000 Hardware Platform Overview
The following shows the front panel of the SPIO card, its interfaces, and other major components.
Figure 12: Switch Processor I/O (SPIO) Card
Table 8: SPIO Callouts
Item
1
2
3
4
5
6
7
8
Description
Card Ejector Levers—Use to insert/remove card to or from the chassis.
Interlock Switch—In its Down position the interlock switch notifies the system to safely power
down the card prior to its removal.
Card Level Status LEDs—Show the status of the card. See Applying Power and Verifying
Installation for definitions.
Optical Gigabit Ethernet Management LAN Interfaces—Two Small Form-factor Pluggable
(SFP) optical Gigabit Ethernet interfaces to connect optical transceivers.
10/100/1000 Mbps Ethernet Management LAN Interfaces—Two RJ-45 interfaces, supporting
10/100 Mbps or 1 Gbps Ethernet.
Console Port—RJ-45 interface used for local connectivity to the command line interface (CLI).
See Cabling the Switch Processor Input/Output Line Card for more information.
BITS Timing Interface (Optional) —Either an analog E1 BNC coaxial connector or T1 (DS-1)
3-pin wire-wrap connector. Used for application services that use either the OLC2 or CLC2 line
cards.
CO Alarm Interface—Dry contact relay switches, allowing connectivity to central office, rack, or
cabinet alarms. See Applying Power and Verifying Installation for more information.
Switch Processor I/O (SPIO) Card

ASR 5000 Installation Guide

21