Chassis Configurations - Cisco ASR 5000 Installation Manual

Chassis Configurations

• SNMP support for event notification
Figure 1: ASR 5000 Chassis
Chassis Configurations
The system is designed to scale from a minimum configuration, as shown in the table below, to a fully-loaded
redundant configuration containing a maximum of 48 cards.
If session recovery is enabled, the minimum number of packet processing cards per chassis increases from
one to four cards. Three packet processing cards are active and one packet processing card is standby
(redundant). This minimal configuration is designed to protect against software failures only.
Table 1: Minimum Card Configurations
Component
Application Cards
System Management Card (SMC)
Packet Services Card (PSC)
Packet Services Card Type A
(PSCA)
ASR 5000 Installation Guide
2
Supported ASR Redundant HW
5000 Product Configuration
(Note 1)
All 2
End of Life (not supported in Release 16.0+)
End of Life (not supported in Release 16.0+)
ASR 5000 Hardware Platform Overview
Redundant HW + Maximum per
SW Configuration Chassis
(Note 2)
2 2