Cabling The Optical Sfp+ Interface - Cisco ASR 5000 Installation Manual

Cabling the Gigabit Ethernet Line Cards
Table 43: SFP+ Modules Supported by the XGLC
Module Type
10G Base-SR
10G Base-LR
XGLCs can be installed in chassis slots 17 through 23 and 26 through 32. These cards should always be
installed directly behind their respective PSCs, PSC2s, or PPCs, but they are not required behind any redundant
packet processing cards (those operating in Standby mode).
The following Light Emitting Diodes (LEDs) are provided on the Gigabit Ethernet line cards:
• Link: This green LED shows whether or not the line card is connected to the network. The LED is
• Activity: This green LED shows when data is transmitted or received. The LED is illuminated when
Important

Cabling the Optical SFP+ Interface

To interconnect the optical SFP+ interface on the XGLC, follow the instructions below.
Card Interface
Identification Type
Ethernet 10G Fiber, LC
SR duplex
female
connector
Ethernet 10G Fiber, LC
LR duplex
female
connector
illuminated when the card is connected.
data is passing through the interface.
Because of the optical SFP interface, this product has been tested and found to comply with the limits for
Class 1 laser devices for IEC825, EN60825, and 21CFR1040 specifications.
Cabling the Optical SFP+ Interface
Cable Specifications
Fiber Type: Multi-mode fiber (MMF), 850 nm wavelength
Core Size (microns)/Range:
• 62.5/902.23 feet (275 meters)
• 50/1640.42 feet (500 meters)
• 62.5um/33m (OM1)
• 50um 500MHz-km/82m (OM2)
• 50um 2000MHz-km/300m (OM3)
Minimum Tx Power: -7.3 dBm
Rx Sensitivity: -11.1 dBm
Fiber Type: Single-mode fiber (SMF), 1310 nm wavelength
Core Size (microns)/Range: 9/32808.4 feet (10 Kilometers)
Minimum Tx Power: -11.0 dBm
Rx Sensitivity: -19 dBm
ASR 5000 Installation Guide
115