Basic Setting Of The Thread Cutter - Dürkopp Adler 967 Service Instructions Manual

5. Move the control cam (3) to a distance of 1 mm from the lever (2), man-
6. Tighten the screws (4).

14.2 Basic setting of the thread cutter

Correct setting
When the stop lever (6) is touching the baseplate (5) of the machine:
 The distance between the control cam (4) and the roller (1) must be
 The piston of the pneumatic cylinder must be 0.5 to 1 mm from the
Cover
• Upper right cover ( page 11).
• Tilt the upper section ( page 10).
76
ually press the lever down and manually rotate the control cam until the
pulley (7) engages in the setting gully (6).
0.1 to 0.2 mm.
base of the cylinder (it must not be touching it).
Adjusting the thread cut-off
Service instructions 967 - 00.0 - 12/2014