Removal Of The Top Cover Plate Of The Light Processor Compartment - Barco DP2K SLP Series User And Installation Manual

15. Removal and installation of the projector covers

15.5 Removal of the top cover plate of the Light Processor compartment

To access the top cover plate of the Light Processor compartment the projector top cover has to be removed
first. This procedure assumes that the projector top cover is already removed.
C
AUTION
result in a tamper event. An authorization to clear the security warning on the projector, after closing off the
Light Processor compartment, will be needed!
Necessary tools
Allen wrench 3 mm
How to remove the top cover plate from the Light Processor compartment?
1. Remove the four screws (reference 1 image 15-6) at the top of the cover plate. Use a 3 mm Allen wrench.
1
Image 15-6
2. Remove the top cover plate as follows:
a) Grab the top cover plate by the two handles (reference 2 image 15-7) and slide it towards the front side (lens side) of the
projector. All latches (reference 3 image 15-7) must become free.
b) Tilt the top cover plate as illustrated.
c) Move the top cover plate away from the projector.
136
:
Opening the Light Processor compartment by removing the top cover plate or side cover plate will
R5906847 DP2K SLP SERIES 02/06/2017