Downloading New Software - Ricoh G035 Service Manual

4.4 DOWNLOADING NEW SOFTWARE

In this machine, the BICU software is upgraded using a flash memory card.
The program is downloaded from the flash memory card to the BICU.
NOTE: The procedure for how to write the source software data from a flash
memory card writer to a flash memory card is described in the SwapBox
FTL manual.
1. Turn off the main power switch.
2. Remove the flash memory card cover [A].
3. Plug the flash memory card [B] into the card slot.
NOTE: Make sure that the surface printed "B" faces the front of the machine.
4. Turn on the main power switch.
NOTE: 1) The machine does not display any message during the download
procedure.
2) This procedure takes about 3 minutes.
5. After 3 minutes pass, turn off the machine, remove the card from the slot, and
turn the machine back on.
G035
DOWNLOADING NEW SOFTWARE
[B]
B
4-24
[A]
G035M919.WMF
SM