Service Program Mode Tables - Ricoh G035 Service Manual

4.2.2 SERVICE PROGRAM MODE TABLES

NOTE: 1) In the Function column, comments are in italics.
2) In the Settings column, the default value is in bold letters.
1. Controller SP
Menu
Menu Menu
Level 2 Level 3
Flash SYS
1
From Parallel
1
Flash SYS
2
From PCMCIA
Flash PS
1
From Parallel
2
Flash PS
2
From PCMCIA
Copy ROM
3
4 Format Disk
5 Print Job Log
6 Print Err Log
7 Clear Job Log Clears the print/job counter
8 Clear Err Log
9 Loop Back
2. Engine SP
Menu
Menu Menu
Level 2 Level 3
Leading Edge
Registration
1
1
Side-to-Side
Registration
(Tray 1)
2
G035
Downloads the printer controller firmware from a PC
through the parallel port.
Downloads the printer controller firmware using an IC
card through the PCMCIA port.
Downloads the PostScript firmware from a PC through
the parallel port.
Downloads the PostScript firmware using an IC card
through the PCMCIA port.
Copies the printer controller firmware between ROM
DIMM and printer controller
Formats the hard disk drive
Prints the print/job count log page
Prints the printer error log page
Clears the error log counter
Performs the parallel loop back test
Function
Adjusts the printing leading edge
registration using the trimming area
pattern (SP2-12, No.).
Use the or key to toggle between
+ and – before entering the value.
The specification is 3 ± 2 mm. See
"Replacement and Adjustment - Copy
Adjustments" for details on SP2-1 and
2-2.
Adjusts the printing side-to-side
registration from the 1st paper feed
station using the trimming area
pattern (SP2-12, No.10).
Use the or key to toggle between
+ and - before entering the value.
The specification is 2 ± 1.5 mm.
4-6
SERVICE PROGRAM MODE
Function
+9.0 ~ –9.0
0.1 mm/step
[+3.0 mm]
+9.0 ~ –9.0
0.1 mm/step
[+3.0 mm]
Settings
[Default]
SM