Transfer Belt Cleaning Blade/Toner Overflow Sensor - Ricoh G035 Service Manual

6.6.3 TRANSFER BELT CLEANING BLADE/TONER OVERFLOW
SENSOR
Transfer Belt Cleaning Blade
1. Remove the transfer belt. (See Transfer Belt.)
2. Remove the transfer belt cleaning blade [A] (3 screws).
NOTE: 1) Do not touch the edge of the new blade.
2) Check that there is no dust/no damage on the edge of the new blade.
Toner Overflow Sensor
1. Remove the transfer belt cleaning blade.
2. Turn over the transfer unit and empty the used toner in the transfer unit.
3. Remove the toner overflow sensor [B] (1 screw, 3 terminal wires).
NOTE: When re-installing the terminal wires, the wire color order is red, purple,
and blue, from the top.
SM
[B]
6-21
TRANSFER UNIT
[A]
G035R503.WMF
G035