Bulb Replacement - Suzuki sq-416-420-625 Service Manual

HOT
LH. HEADLIGHT
SPOT
LH steering vehicle shown
X-X:Horizontal center line of headlight bulbs
A-A:Vertical center line of left headlight bulb
B-B:Vertical center line of right headlight bulb
2. For right / left adjustment
3. For up / down adjustment
(for vehicle without leveling system)
4. For up / down adjustment
(for vehicle with leveling system)
5. Headlight leveling actuator

BULB REPLACEMENT

WARNING:
Don't touch when the bulb is hot.
1) Disconnect negative cable at battery.
2) Disconnect harness from bulb.
3) Remove socket cover and bulb.
4) Replace bulb and install in reverse removal procedure.
HEADLIGHT AIMING WITH SCREEN
NOTE:
D Unless otherwise obligated by local regulations, adjust
headlight aiming according to following procedure.
D After replacing headlight, be sure to perform its aiming.
D When inspecting and adjusting headlight with leveling sys-
tem, make sure to set the leveling switch to "0" position with
IG switch ON.
1. Screen
Before adjustment, make sure the following.
a) Place vehicle on a flat surface in front of blank wall as below
b) Adjust air pressure of all tires to a specified value respectively.
c) Bounce vehicle body up and down by hand to stabilize suspen-
RH. HEADLIGHT
d) Carry out one driver aboard.
Adjustment
1) Check to see if hot spot (high intensity zone) of each main (low)
2) If headlight aiming is not set properly, align it to specification by
ahead of headlight surface.
Clearance "a": 10 m (32.8 ft)
sion.
Driver's weight: 75 kg (165 lb)
beam axis falls as illustrated.
Clearance "H": Approx. 130 mm (5.15 in.)
adjusting aiming screw and aiming gear.
LIGHTING SYSTEM 8B-7