Suzuki sq-416-420-625 Service Manual page 745

CODE 25 – DRIVER AIR BAG INITIATOR CIRCUIT SHORT TO POWER CIRCUIT (Page 2 of 2)
STEP
3 1) With ignition switch OFF, disconnect Special
Tool (B) then reconnect contact coil connector
located near the base of the steering column.
2) Remove driver air bag (inflator) module from
steering wheel (Refer to SECTION 3C1).
3) Check proper connection to driver air bag
(inflator) module at terminals in "D" connector.
4) If OK then connect Special Tool (B) to driver
air bag (inflator) module disconnected at
step 2).
5) With ignition switch ON, is DTC 25 current?
Fig. for STEP 1 and 2
Fig. for STEP 3
STEERING
WHEEL
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
3) Repeat "Air Bag Diagnostic System Check Flow Table", referring to p.10B-11 to confirm that the trouble
has been corrected.
ACTION
BASE OF COLUMN
YES
1) Ignition switch OFF.
2) Replace contact coil
assembly (Refer to
SECTION 3C1).
Fig. for STEP 2
(A)
Special Tool
(A): 09932-76010
(B): 09932-75010
AIR BAG SYSTEM 10B-39
NO
1) Ignition switch OFF.
2) Replace driver air bag
(inflator) module
(Refer to SECTION
3C1).