Suzuki sq-416-420-625 Service Manual page 781

1. Connect one banana plug to positive terminal of
power source (12V vehicle battery) and then the
other to negative terminal to immediately deploy.
2. Short to two deployment harness leads.
WARNING:
D After deployment, the metal surfaces of the air bag (in-
flator) module will be very hot. Do not touch the metal
areas of the air bag (inflator) module for about 30 min-
utes after deployment.
D Do not place the deployed air bag (inflator) module
near any flammable objects.
D Do not apply water, oil, etc. to deployed air bag (infla-
tor) module.
D If the deployed air bag (inflator) module must be
moved before it is cool, wear gloves and handle it by
using nonmetal material such as the air bag and vinyl
trim.
Failure to follow procedures may result in fire or per-
sonal injury.
13) Separate the two banana plugs on the deployment harness.
14) Connect the deployment harness to the power source (12V ve-
hicle battery) to immediately deploy the driver or passenger air
bag.
15) Disconnect the deployment harness from power source (12V
vehicle battery) and short the two deployment harness leads
together by fully seating one banana plug into the other.
16) In the unlikely event that the driver or passenger air bag (infla-
tor) module did not deploy after following these procedures,
proceed immediately with Steps 21) through 24). If the air bag
(inflator) module did deploy, proceed with Steps 17) through
20).
AIR BAG SYSTEM 10B-75