Suzuki sq-416-420-625 Service Manual page 266

1. Circlip
Differential side
[RH]
[LH]
"A": Fill grease 90 – 95 g (3.2 – 3.4 oz)
FRONT DRIVE SHAFT / SHAFT BEARING, OIL SEAL 4A2-7
7) Apply grease to entire surface of cage.
Use joint grease in tube included in spare part or joint grease
(99000-25120).
8) Insert cage into outer race and fit circlip into groove of outer
race.
CAUTION:
Position opening of circlip "a" so that it will not be lined
up with a ball.
9) Apply grease to inside of outer race, and fit boot to outer race.
Fill up inside of boot with joint grease.
"A": Joint Grease 99000-25120
(about 90 – 95g /3.2 – 3.4 oz)
10) Fitting boot to outer race, adjust so that measurements "b" and
"c" become as indicated in figure.
Length"b": 203.2 – 213.2 mm
(8.00 – 8.40 in.)
196.8 – 206.8 mm
(7.75 – 8.14 in.)
"c": 125.5 – 135.5 mm
(4.94 – 5.33 in.)
127.5 – 137.5 mm
(5.02 – 5.41 in.)
Before fixing boot band, insert screwdriver into boot on joint
side and allow air to enter boot so that air pressure in boot be-
comes the same as atmospheric pressure.
11) Clamp boot band. Check boots for distortion or dent.
. . . . . . . . . M/T vehicle with
H25 engine
. . . . . . . . . M/T vehicle with
H25 engine