Suzuki sq-416-420-625 Service Manual page 312

5A-18 BRAKES PIPE / HOSE / MASTER CYLINDER
1. LSPV lever
2. Stopper bolt (if equipped)
3. Coil spring "A": Don't turn
2) Torque each bolt and nut to specification as indicated respec-
3) Upon completion of installation, fill reservoir tank with specified
4) After bleeding air, check that LSPV is installed properly, referring
1. LSPV spring bolt
2. LSPV bolt
3. Brake pipe flare nut
4. Air bleeding plug
INSPECTION & ADJUSTMENT
Confirm the following before inspection and adjustment.
D Fuel tank is filled with fuel fully.
D Vehicle is equipped with spare tire, tools, jack and jack handle.
D Vehicle is free from any other load.
With vehicle in above conditions;
1) Place it on level floor.
2) Push up (for 5 door model) or push down (for 3 door model)
3) Spring length "L" should be the value specified below.
4) If it isn't, adjust it to specification by changing stay positions as
(a)
tively in figure.
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
.
(b): 16 N m (1.6 kg-m, 11.5 lb-ft) (brake flare nut)
.
(c): 7.5 N m (0.75 kg-m, 9.0 lb-ft) (bleeder plug)
fluid and bleed air from brake system.
NOTE:
Make sure to bleed air from LSPV bleeder without failure.
to following INSPECTION & ADJUSTMENT.
LSPV lever with finger till it stops and measure length "L" of coil
spring as it is pulled.
Spring length (between spring end and spring bolt)
"L": 103 mm (4.06 in.)
"L": 157 mm (6.18 in.)
shown in figure. After adjustment, tighten bolt to specified
torque.
For details, refer to left figure.
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
NOTE:
Check to make sure that LSPV body and brake pipe joints
are free from fluid leakage. Replace defective parts, if any.
. . . . . (5 door model)
. . . . . (3 door model)