Suzuki sq-416-420-625 Service Manual page 791

1. Seat belt pretensioner (retractor assembly)
2. Webbing
3. 185 cm (6 ft) of clearance
4. Exhaust hole
1. Stretch deployment harness to full length 10 m (33 ft).
2. Connect connectors.
3. Power source (12V vehicle battery)
4. Short the two deployment harness leads.
5. Seat belt pretensioner harness
6) Pull out the webbing fully as shown at the left and cut it at the
7) Clear a space on the ground about 185 cm (6 ft) in diameter
8) Place the seat belt pretensioner as shown in the figure on the
4
9) Stretch the deployment harness from the seat belt pretension-
10) Place a power source near the shorted end of the deployment
11) Verify that the area around the seat belt pretensioner is clear
12) Verify that the seat belt pretensioner is placed as shown in the
13) Connect the seat belt pretensioner harness to the deployment
root of the pretensioner (retractor assembly) as shown in the
figure.
WARNING:
As the drum of the retractor assembly turns very quick-
ly as soon as the webbing is cut, fix the retractor assem-
bly with a vise on the workbench and keep your hands
and fingers away from it when cutting the webbing.
where the seat belt pretensioner is to be activated. A paved,
outdoor location where there is no activity is preferred. If an out-
door location is not available, a space on the shop floor where
there is no activity and sufficient ventilation is recommended.
Ensure no loose or flammable objects are within the activation
area.
ground in the space just cleared.
er to its full length 10 m (33 ft).
harness. Recommended application: 12 Volts minimum, 2
amps minimum. A vehicle battery is suggested.
of all people and loose or flammable objects.
figure on the ground in the space just cleared.
harness connector and lock the connector with lock lever.
Special Tool
(A): 09932-75030
AIR BAG SYSTEM 10B-85