Suzuki sq-416-420-625 Service Manual page 474

7B1-72 AUTOMATIC TRANSMISSION (4 A / T)
1. Ignition switch assembly
2. Clamp screw
3. Outer end
1. Interlock cable
2. Steering column
3. Steering column
holder
Type-1
1. Interlock cam
2. Lever plate
3. Interlock cable
4. Pin with 4 mm (0.15 in.) dia.
Installation
1) Shift select lever to "N" range and turn ignition key to "ACC"
position.
2) Connect inner end of interlock cable to key interlock lever (Igni-
tion switch side).
3) Install outer end bracket of interlock cable to ignition switch as-
sembly, and tighten screw to specified torque.
Tightening Torque
.
(a): 2.2 N m (0.22 kg-m, 1.5 lb-ft)
4) Pass and connect interlock cable as shown at the left figure.
TYPE-1
5) Fix interlock cam by inserting pin with about 4 mm (0.15 in.) dia.
into holes of cam and lever plate.
6) Install cable end to interlock cam and stud bolt and after making
sure that cable outer is pushed in arrow direction B by leaf
spring, tighten mounting nut to specified torque. Remove pin.
Tightening Torque
.
(a): 13 N m (1.3 kg-m, 9.5 lb-ft)
7) Turn ignition key to "ACC" position and shift select lever to "N"
range, and check for the followings.
a. When select lever is shifted at "P" range with knob button
depressed, ignition key can not be turned from "ACC" to
"LOCK" position.
b. When knob button is released, ignition key can be turned to
"LOCK" position.
c. When ignition key is at "LOCK" position, select lever can not
be shifted from "P" to any other range.
8) Install console box.
9) Install steering column cover.
10) Adjust steering column or tighten steering column bolts.
11) Install steering column hole cover.
12) If equipped with air bag system, enable air bag system.
Refer to "Enabling Air bag System" in Section 10B.