Wheel Cylinder - Suzuki sq-416-420-625 Service Manual

5C-12 PARKING AND REAR BRAKE

WHEEL CYLINDER

REMOVAL
1) Perform steps 1) to 5) of BRAKE DRUM REMOVAL.
2) Perform steps 2) to 4) of BRAKE SHOE REMOVAL.
3) Loosen brake pipe flare nut (or nuts) but only within the extent
4) Remove wheel cylinder mounting bolts. Disconnect brake pipe
1. Bleeder plug cap
INSPECTION
Inspect wheel cylinder disassembled parts for wear, cracks, corro-
sion or damage.
NOTE:
Clean wheel cylinder components with brake fluid.
INSTALLATION (For non sealed type)
1) Take off bleeder plug cap from brake pipe and connect pipe (or
1. Wheel cylinder
2) Tighten wheel cylinder to brake back plate to specified torque.
3) Torque flare nut (or nuts) of brake pipe which was connected in
1. Brake back plate
2. Brake pipe flare nut
3. Brake pipe
4. Wheel cylinder bolts
that fluid does not leak.
(or pipes) from wheel cylinder and put wheel cylinder bleeder
plug cap onto pipe to prevent fluid from spilling.
pipes) to wheel cylinder just enough to prevent fluid from leak-
ing.
Tightening Torque
.
(a): 8.5 N m (0.85 kg-m, 6.5 lb-ft)
step 1) to specification.
Tightening Torque
.
(b): 16 N m (1.6 kg-m, 12.0 lb-ft)