Suzuki sq-416-420-625 Service Manual page 776

10B-70 AIR BAG SYSTEM
1. Passenger air bag (inflator) module
2. Instrument panel
3. Glove box
INSPECTION
WARNING:
Never measure resistance of passenger air bag (inflator)
module or disassemble it. Otherwise personal injury may
result.
CAUTION:
If air bag (Inflator) module was dropped from a height or 90
cm (3 ft) or more, it should be replaced.
Check air bag (inflator) module appearance visually for following
symptoms and if any one of them is applicable, replace with a new
one.
D Air bag has deployed.
D There is a crack in trim cover (pad surface).
D Wire harness or connector is damaged.
D Air bag (inflator) module is damaged or a strong impact
(e.g., dropping) was applied to it.
INSTALLATION
1) Install passenger air bag (inflator) module to vehicle.
2) Tighten passenger air bag (inflator) module attaching bolts and
screws to specified torque.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 16.5 lb-ft)
(b): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
3) Connect negative battery cable to battery.
4) Enable air bag system. Refer to "Enabling Air Bag System" earli-
er in this section.