Suzuki sq-416-420-625 Service Manual page 17

0A-14 GENERAL INFORMATION
SHORT CIRCUIT CHECK (Wire harness to ground)
To other
1) Disconnect negative cable from battery.
parts
2) Disconnect connectors at both ends of the circuit to be checked.
3) Measure resistance between terminal at one end of circuit (A-1
Other parts
4) Disconnect the connector included in circuit (connector B) and
To other
parts
NOTE:
If the circuit to be checked is connected to other parts, dis-
connect all connectors of those parts.
Otherwise, diagnosis will be misled.
terminal in figure) and body ground. If continuity is indicated, it
means that there is a short to ground between terminals A-1 and
C-1 of the circuit.
measure resistance between A-1 and body ground.
If continuity is indicated, it means that the circuit is shorted to the
ground between terminals A-1 and B-1.