Suzuki sq-416-420-625 Service Manual page 234

1. Parking brake
cable hanger
2. Cross member
3. Clamp
4. Chassis frame
INSTALLATION
1) Install coil spring on spring seat of axle housing and then raise
1. Rear axle housing
2. Spring seat
3. Coil spring
4. Stepped part
2) Install shock absorber lower bolt. For its proper installing direc-
1. Body center
2. Body outside
3) Install wheel speed sensor clamp (if equipped) and E-ring, and
4) Connect cable hanger to chassis frame and clamp to cross
5) Install wheel and tighten wheel nuts to specified torque.
6) Lower hoist and tighten absorber lower nut to specified torque.
1. Body center
2. Body outside
axle housing.
NOTE:
When seating coil spring, mate spring end with stepped
part of rear axle spring seat as shown.
tion, refer to figure.
Nut should not be tightened.
connect breather hose to axle housing.
member. Remove floor jack from axle housing.
Tightening Torque
.
(a): 100 N m (10.0 kg-m, 72.5 lb-ft)
Tightening Torque
.
(b): 85 N m (8.5 kg-m, 61.5 lb-ft)
NOTE:
For tightening of lower nut, refer to NOTE given under
SHOCK ABSORBER INSTALLATION in this section.
REAR SUSPENSION 3E-7