Suzuki sq-416-420-625 Service Manual page 168

3B1-24 POWER STEERING (P / S) SYSTEM
15) Gradually tighten new pump cover bolts to specified torque.
1. Pump cover
16) Apply power steering fluid to O-ring of terminal switch.
1. Pressure switch
17) Install pressure switch to pump body.
18) Apply power steering fluid to relief valve (flow control valve).
19) Install relief valve (flow control valve) to pump body.
20) Install flow control spring.
21) Apply power steering fluid to O-rings of plug.
22) Install O-rings to plug.
23) Tighten plug to specified torque.
24) Apply power steering fluid to O-ring of suction connector.
25) Install O-ring to suction connector.
1. Suction connector
2. O-ring
26) Install suction connector to pump body as shown in figure.
1. Suction connector
NOTE:
After installing pump cover, check to make sure that shaft
can be turned by hand.
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
Tightening Torque
.
(a): 28 N m (2.8 kg-m, 20.0 lb-ft)
Tightening Torque
.
(a): 60 N m (6.0 kg-m, 43.5 lb-ft)
Tighten new suction connector bolts to specified torque.
Tightening Torque
.
(a): 10 N m (1.0 kg-m, 7.5 lb-ft)